Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Power Steering Fluid Reservoir

Courtesy of FORD MOTOR CO.

Using a suitable suction device, drain the power steering fluid reservoir.
Remove the 3 fluid reservoir bolts.
- To install, tighten to 11 Nm (8 lb-in).
Release the clamp and disconnect the return line from the fluid reservoir.
Release the clamp and disconnect the suction line from the fluid reservoir.
Remove the power steering fluid reservoir.
To install, reverse the removal procedure.
- Fill the power steering system. For additional information, refer to STEERING SYSTEM-GENERAL INFORMATION .