Removal and Installation
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The brake pedal and the accelerator pedal must be in the same position when installing a new cable or a new accelerator pedal. The pedals must be all the way forward or all the way rearward.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Disconnect the accelerator pedal electrical connector.
- Disconnect the accelerator pedal assembly drive cable.
- Remove the 3 accelerator pedal assembly bolts and the accelerator pedal assembly.
- To install, tighten to 25 Nm (18 lb-in).
- To install, reverse the removal procedure.