System Airflow Description - EATC: Panel/Floor
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
When PANEL/FLOOR is selected:
- The recirc request button is enabled. If the recirc request button is selected (indicator on), the air inlet door actuator closes off outside air from entering the passenger compartment. If the recirc request button is not selected (indicator off), the air inlet door actuator admits only outside air into the passenger compartment.
- The floor/defrost door is in the floor position and the panel door actuator partially opens, directing airflow to the floor duct and the instrument panel A/C registers.
- Blended air temperature is available.
- The A/C request button is enabled. The A/C compressor will operate and the indicator will illuminate if the A/C request button is selected and the outside temperature is above approximately 2°C (35°F).
- The blower motor is on.