System Airflow Description - EATC: Auto

When AUTO is selected:

• The temperature control setting is manually set to the desired setting.
• The air inlet door actuator is automatically controlled by the EATC module, based on the temperature setting.
• The mode door actuators are automatically controlled by the EATC module based on the temperature setting.
• The A/C compressor is automatically controlled by the EATC module based on the temperature setting. The A/C compressor will not operate if the outside temperature is below approximately 2°C (35°F). The A/C indicator will automatically turns ON above approximately 2°C (35°F) and automatically turns OFF below approximately -0.5°C (31°F)
• The A/C request button and the RECIRC request button can be manually selected. When manually selected, the A/C indicator will not change state with the changing outside temperature.
• The blower motor is on. The blower motor speed is automatically controlled by the EATC module based on the temperature setting, but can be manually overridden.