LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 986 (Engine - 4.2L -- F150 Pickup) >> In-Vehicle Repair >> Valve Tappet >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: If removing more than one valve tappet, mark the components removed for correct location.
  1. Remove the lower intake manifold. For additional information, refer to LOWER INTAKE MANIFOLD .
  2. Remove the push rods. For additional information, refer to PUSH ROD .
    3. CAUTION: If the tappet guide plates are to be reused, they must be installed in their original locations. Mark the tappet guide plates for location.
  3. Remove the 4 tappet guide plate bolts and the 2 tappet guide plates.
    • To install, tighten to 12 Nm (9 lb-ft).
    4. CAUTION: If the valve tappets are to be reused, they must be installed in their original locations. Mark the valve tappets for location.
  4. Remove the valve tappets.
  5. Inspect the valve tappets. For additional information, refer to ENGINE SYSTEM-GENERAL INFORMATION .
    6. NOTE: Lubricate the valve tappets with clean engine oil.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals