LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 985 (Electronic Engine Control System -- F150 Pickup) >> Removal And Installation >> Mass Air Flow (MAF) Sensor - 5.4L (3V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the MAF sensor electrical connector.
  3. Remove the bolts and the MAF sensor.
    • To install, tighten to 7 Nm (62 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals