LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 985 (Electronic Engine Control System -- F150 Pickup) >> Removal And Installation >> Mass Air Flow (MAF) Sensor - 4.6L (2V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the clamp on the air cleaner and separate the tray from the cover.
  2. Disconnect the mass air flow (MAF) sensor electrical connector and detach the connector retainer.
  3. Remove the grommet from the air cleaner cover and slide it down the electrical harness.
  4. Pull the air cleaner inner cover and MAF sensor out of the air cleaner cover.
  5. Disconnect the MAF sensor electrical connector and remove the inner cover and MAF sensor assembly.
  6. Remove the bolts and the MAF sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals