LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 985 (Electronic Engine Control System -- F150 Pickup) >> Removal And Installation >> Mass Air Flow (MAF) Sensor - 4.2L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Release the clamp and detach the air cleaner cover from the air cleaner tray.
  3. Lift the air cleaner tray from the grommets and remove the air cleaner tray.
  4. Disconnect the mass air flow (MAF) sensor electrical connector and detach the electrical connector retainer.
  5. Remove the grommet from the air cleaner cover and slide it down the wiring harness to allow the removal of the air cleaner inner cover and the MAF sensor.
  6. Detach the air cleaner inner cover and pull the inner cover and MAF sensor out of the air cleaner cover and disconnect the MAF sensor jumper wire.
  7. Remove the bolts and the MAF sensor.
    • To install, tighten to 10 Nm (89 lb-in).
scientia non olet · About LEMON Manuals