LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 985 (Electronic Engine Control System -- F150 Pickup) >> Removal And Installation >> Knock Sensor (KS) - 4.6L (2V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to ENGINE - 4.6L (2V) .
  2. Disconnect the knock sensor (KS) electrical connector.
  3. Remove the bolt and the KS.
    • To install, tighten to 20 Nm (15 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals