LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 985 (Electronic Engine Control System -- F150 Pickup) >> Removal And Installation >> Clutch Pedal Position (CPP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the clutch pedal position (CPP) switch electrical connector.
  3. Detach the pushrod from the clutch lever pin.
  4. Remove the CPP switch.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals