LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 985 (Electronic Engine Control System -- F150 Pickup) >> Removal And Installation >> Camshaft Position (CMP) Sensor - 5.4L (3V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

    Both sides 

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .

    2. LH side 

  2. Remove the air cleaner inlet pipe and resonator. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .

    3. Both sides 

  3. Disconnect the CMP sensor electrical connector.
  4. Remove the bolt and the CMP sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals