LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 985 (Electronic Engine Control System -- F150 Pickup) >> Removal And Installation >> Camshaft Position (CMP) Sensor - 4.2L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Drain the engine cooling system. For additional information, refer to ENGINE COOLING .
    3. NOTE: Clean and inspect the heater outlet tube O-ring seal. Install a new O-ring seal if necessary. Lubricate the O-ring seal with clean engine coolant.
  3. Remove the bolt and position the heater outlet tube aside.
    • To install, tighten to 10 Nm (89 lb-in).
  4. Disconnect the camshaft position sensor (CMP) sensor electrical connector.
  5. Remove the bolts and the CMP sensor.
    • To install, tighten to 3 Nm (27 lb-in).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals