LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 983 (Engine Cooling System -- F150 Pickup) >> Removal And Installation >> Coolant Pump - 5.4L (3V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  2. Remove the cooling fan. For additional information, refer to COOLING FAN - BLADE, CLUTCH AND SHROUD .
  3. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .
  4. Remove the bolts and the coolant pump pulley.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. Remove the bolts and the coolant pump.
    • To install, tighten to 25 Nm (18 lb-ft).
  6. Remove and discard the O-ring seal.
  7. Clean the O-ring seal mating surface with metal surface prep. Follow the directions on the packaging.
  8. To install, reverse the removal procedure.
    • Install a new O-ring seal and lubricate it with clean engine coolant.
scientia non olet · About LEMON Manuals