LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 982 (Fuel System & Engine Controls - 5.4L (3V) -- F150 Pickup) >> Removal And Installation >> Fuel Pump Driver Module (FPDM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Lower the spare tire.
  3. Disconnect the FPDM electrical connector.
  4. Remove the bolts and the FPDM.
    • To install, tighten to 10 Nm (89 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals