LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Automatic Transmission -- F150 Pickup) >> In-Vehicle Repair >> Digital Transmission Range (TR) Sensor >> Removal

Digital Transmission Range (TR) Sensor: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Manual shift lever must be in the NEUTRAL position.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the digital TR electrical connector.
    Fig 1: Disconnecting Digital TR Electrical Connector
    G03929749Courtesy of FORD MOTOR CO.
    3. CAUTION: Do not pry on the swivel tube to disconnect the transmission shift linkage.
    Fig 2: Disconnecting Manual Control Lever Shift Control Cable
    G03888604Courtesy of FORD MOTOR CO.
  3. Disconnect the manual control lever shift control cable.
    4. CAUTION: Discard the outer manual control lever shaft nut. Do not reuse the nut.
    Fig 3: Removing Manual Control Lever
    G03929636Courtesy of FORD MOTOR CO.
  4. Remove the manual control lever.
    1. Remove the nut.
    2. Remove the lever.
  5. Remove the digital TR sensor bolts and the digital TR sensor.
    Fig 4: Removing Digital TR Sensor Bolts And Digital TR Sensor
    G03888527Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals