Pinpoint Test G: Solenoid Mechanical Failure
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Repair all other DTCs before repairing the following DTCs: P1714, P1715, P1740.
- G1 ELECTRONIC DIAGNOSIS
- Connect the scan tool.
- Carry out KOEO Test.
- If any of the following DTCs are present, continue with this test: P1714, P1715, P1740.
- Are other DTCs present for TFT or shift solenoids?
- Yes : REPAIR the other DTCs first. CLEAR DTCs and CARRY OUT TRANSMISSION DRIVE CYCLE TEST . REPEAT Quick Test.
- No : INSTALL a new solenoid and or body. REFER to the DIAGNOSTIC TROUBLE CODE (DTC) CHARTS for code description. GO to G2.
- G2 TRANSMISSION DRIVE CYCLE TEST
- Carry out transmission drive cycle test.
- Carry out on-board diagnostic test.
- Does the vehicle upshift and downshift OK?
- Yes : GO to G3.
- No : REFER to DIAGNOSIS BY SYMPTOM to diagnose shift concerns.
- G3 RETRIEVE DTCs
- Connect the scan tool.
- Carry out KOEO Test until continuous DTCs have been displayed.
- Are DTCs P1714, P1715, P1740 still present?
- Yes : INSTALL a new PCM. REFER to FUEL CHARGING & CONTROLS - 4.2L , FUEL CHARGING & CONTROLS - 4.6L (2V) or FUEL CHARGING & CONTROLS - 5.4L (3V) . ROAD TEST and REPEAT Quick Test.
- No : Testing completed. If a concern still exists, REFER to DIAGNOSIS BY SYMPTOM for concern diagnosis.