LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 974 (Automatic Transmission -- F150 Pickup) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Engagement Concern: Harsh Forward

Engagement Concern: Harsh Forward

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
ENGAGEMENT CONCERN: HARSH FORWARD

Possible Component Reference/Action
204 - ELECTRICAL ROUTINE 
Powertrain Control System 
  • Electrical inputs/outputs, vehicle wiring harnesses, PCM, TFT sensor, EPC solenoid
  • Carry out Self-Test. REFER to the INTRODUCTION - GASOLINE article for diagnosis and testing of the Powertrain Control System. Carry out engagement test and EPC test. GO to PINPOINT TEST B  or GO to PINPOINT TEST D . Check idle speed. Repair as required. Clear DTCs, road test and repeat Self-Test.
304 - HYDRAULIC/MECHANICAL ROUTINE 
Fluid 
  • Incorrect level
  • Adjust fluid to correct level.
  • Condition
  • Inspect condition of fluid.
Engine Driveline 
  • Looseness in the driveshaft, U-joints or the engine mounts
  • Repair as required.
Incorrect Pressures 
  • High forward clutch pressure, high line pressure, high EPC pressure
Main Controls 
  • Main regulator valve stuck, damaged
  • Inspect and repair as required.
  • Bolts not tightened to specifications
  • Tighten bolts to specifications.
  • Gaskets damaged
  • Inspect for damage and install a new gasket.
  • EPC solenoid stuck or damaged
  • Inspect for damage or contamination. Carry out EPC test in Routine 204. Repair as required.
Case 
  • 2-3 accumulator seal/retainer stuck, damaged
  • Inspect for damage. Repair as required.
Pump Assembly 
  • Bolts not tightened to specifications
  • Tighten bolts to specifications.
  • Porosity/cross leaks
  • Inspect for porosity/leaks. Install a new pump as required.
  • Gaskets damaged
  • Inspect for damage and install a new gasket.
Forward Clutch Assembly 
  • Check balls missing or damaged
  • Inspect for mislocation, poor seating, damage. Install a new forward clutch cylinder.
  • Friction element damaged or worn
  • Inspect for damage. Repair as required.
  • Forward clutch wave spring damaged
  • Inspect for damage. Repair as required.
  • Forward clutch return spring damaged
  • Inspect for damage. Repair as required.