LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 973 (Engine - 5.4L (3V) - F150 Pickup) >> In-Vehicle Repair >> Valve Springs >> Installation

Valve Springs: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: If the components are to be reinstalled, they must be installed into their original locations.
    Fig 1: Using Special Tool To Install Valve Spring, Valve Spring Retainer And Valve Spring Retainer Keys
    G03920063Courtesy of FORD MOTOR CO.
  1. Using the special tool, install the valve spring, the valve spring retainer and the valve spring retainer keys.
  2. Relieve the air pressure from the cylinder.
    3. CAUTION: If the components are to be reinstalled, they must be installed into their original locations.
    NOTE: Lubricate the camshaft roller follower with clean engine oil prior to installation.
    Fig 2: Using Special Tool To Compress Valve Spring And Install Camshaft Roller Follower
    G03919946Courtesy of FORD MOTOR CO.
  3. Using the special tool, compress the valve spring and install the camshaft roller follower.
  4. Install the spark plug. For additional information, refer to ENGINE IGNITION - 5.4L (3V) .
  5. Depending on the valve being serviced, install the LH or RH valve cover. For additional information, refer to VALVE COVER - LH  or VALVE COVER - RH .
scientia non olet · About LEMON Manuals