LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 973 (Engine - 5.4L (3V) - F150 Pickup) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front oil level indicator and tube bolt.
    • To install, tighten to 25 Nm (18 lb-ft).
  2. Remove the rear oil level indicator and tube bolt.
    • To install, tighten to 10 Nm (89 lb-in).
  3. Remove the oil level indicator and tube from the cylinder block.
    • Discard the O-ring seal.
    4. NOTE: Lubricate the new oil level indicator tube O-ring seal with clean engine oil prior to installation.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals