LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 972 (Engine - 4.6L (2V) - F150 Pickup) >> In-Vehicle Repair >> Valve Cover - RH >> Removal

Valve Cover - RH: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the powertrain control module (PCM) and bracket. For additional information, refer to ELECTRONIC ENGINE CONTROLS .
  2. Disconnect the quick connect couplings and remove the positive crankcase ventilation (PCV) tube. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
  3. Remove the bolt and position the transmission fluid level indicator tube aside.
    Fig 1: Removing Bolt And Positioning Transmission Fluid Level Indicator Tube Aside
    G03962374Courtesy of FORD MOTOR CO.
  4. Release the 5 engine wiring harness retainers from the valve cover stud bolts.
  5. Remove the 3 RH valve cover bolts.
  6. Remove the 8 RH valve cover studs.
  7. Remove the nuts and position the suction accumulator aside.
    Fig 2: Removing Nuts And Positioning Suction Accumulator Aside
    G03962375Courtesy of FORD MOTOR CO.
    8. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
  8. Remove the RH valve cover.
    • Clean the valve cover mating surface of the cylinder head with silicone gasket remover and metal surface prep. Follow the directions on the packaging.
    • Discard the valve cover gasket. Clean the valve cover gasket groove with soap and water or a suitable solvent.
scientia non olet · About LEMON Manuals