Timing Drive Components: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Since the engine is not free-wheeling, the timing procedures must be followed exactly or piston and valve damage can occur.

Remove the engine front cover. For additional information, refer to ENGINE FRONT COVER .
Remove the crankshaft sensor ring from the crankshaft.

Fig 1: Removing Crankshaft Sensor Ring From Crankshaft
Courtesy of FORD MOTOR CO.
Rotate the crankshaft until the timing mark on the RH camshaft sprocket is approximately at the 11 o'clock position and the timing mark on the LH camshaft sprocket is approximately at the 12 o'clock position.

Fig 2: Aligning Timing Mark
Courtesy of FORD MOTOR CO.
Install the special tools on the camshaft.

Fig 3: Installing Special Tools On Camshaft
Courtesy of FORD MOTOR CO.

CAUTION: If one or both of the tensioner mounting bolts are loosened or removed, the tensioner-sealing bead must be inspected for seat integrity. If cracks, tears or separation from the tensioner body or permanent compression of the seal bead is observed, install a new tensioner.

Fig 4: Removing Timing Chain Tensioning System From Both Timing Chains

Courtesy of FORD MOTOR CO.

Remove the timing chain tensioning system from both timing chains.
1. Remove the bolts.
2. Remove the timing chain tensioners.
3. Remove the timing chain tensioner arms.
Remove the timing chains and crankshaft sprocket.

Fig 5: Removing Timing Chains And Crankshaft Sprocket
Courtesy of FORD MOTOR CO.
Remove the timing chain guides.
1. Remove the bolts.
2. Remove the LH timing chain guide.
3. Remove the bolts.
4. Remove the RH timing chain guide.
Fig 6: Removing Timing Chain Guides
Courtesy of FORD MOTOR CO.