Axle Carrier Bushing: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The following procedure is applicable for all of the front axle mounting bushings.

NOTE: It is not necessary to remove the axle assembly from the jack.

Remove the axle assembly. For additional information, refer to AXLE ASSEMBLY .
Position the carrier bushing removal tools.
1. Position the front axle mounting bushing cup remover.
2. Position the Drawbolt through front axle mounting bushing cup remover and the bushing.
3. Thread the Bushing Remover onto the Drawbolt.
Fig 1: Positioning Carrier Bushing Removal Tools
Courtesy of FORD MOTOR CO.
Tighten the Drawbolt to remove the carrier bushing.

Fig 2: Tightening Drawbolt To Remove Carrier Bushing
Courtesy of FORD MOTOR CO.