LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 967 (Rear Drive Axle/Differential - Ford 9.75-Inch Ring Gear -- F150) >> In-Vehicle Repair >> Axle Shaft >> Removal

Axle Shaft: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the differential housing cover. For additional information, refer to DIFFERENTIAL HOUSING COVER .
  3. Remove the disc brake caliper bolts and position aside the disc brake caliper.
    • Using mechanic's wire, position aside the disc brake caliper.
    Fig 1: Removing Disc Brake Caliper Bolts
    G03944168Courtesy of FORD MOTOR CO.
  4. Remove the brake disc.
    Fig 2: Removing Brake Disc
    G03913262Courtesy of FORD MOTOR CO.
  5. Remove the differential pinion shaft.
    1. Remove and discard the differential pinion shaft lock bolt.
    2. Remove the differential pinion shaft.
    Fig 3: Removing Differential Pinion Shaft
    G03883948Courtesy of FORD MOTOR CO.
    6. CAUTION: Do not damage the rubber O-rings in the axle shaft grooves.
    Fig 4: Removing U-Washer
    G03883949Courtesy of FORD MOTOR CO.
  6. Remove the U-washer.
    1. Push in on the axle shaft.
    2. Remove the U-washer.
    7. CAUTION: Do not damage the axle shaft oil seal.
    Fig 5: Removing Axle Shaft
    G03883950Courtesy of FORD MOTOR CO.
  7. Remove the axle shaft.
scientia non olet · About LEMON Manuals