Rear Disc Brake: Installation
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Clean any rust or debris from the brake disc and wheel hub.
- Use brake parts cleaner to clean the brake disc and hub surfaces.
- Apply a thin coat of lubricant to the hub flange.
- Install the brake disc on the wheel hub.
- Position the brake caliper and install the 2 bolts.
- Tighten to 30 Nm (22 lb-ft).
CAUTION:
Do not allow the lubricant to make contact with the wheel studs, brake pads or brake disc.