LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 964 (Rear Disc Brake System - F150 Pickup) >> Removal And Installation >> Rear Brake Pads >> Removal

Rear Brake Pads: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
  1. Check the brake fluid level in the brake master cylinder reservoir.
    • If required, remove fluid until the brake master cylinder reservoir is half full.
  2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
    3. CAUTION: Install a new pad if it is worn past the specified thickness above the metal backing plate or rivets. Install new pads in complete axle sets.
  3. Inspect the pads for wear and contamination.
    4. CAUTION: Do not allow the brake caliper to hang from the brake caliper flexible hose. Use a suitable tool to support the brake caliper.
  4. Remove the 2 bolts and position the brake caliper aside.
  5. Measure the brake disc thickness and install a new brake disc if it is not within specification.
  6. Remove the brake pads and the 2 spring clips.
    • Discard the spring clips.
  7. Inspect the disc brake anchor plate assembly.
    • Check the guide pin boots for damage.
    • Check the guide pins for binding and damage.
    • Replace worn or damaged boots. Lubricate the guide pins.
scientia non olet · About LEMON Manuals