LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 962 (Noise, Vibration & Harshness -- F150 Pickup) >> Diagnosis And Testing >> Noise, Vibration and Harshness (NVH) >> Pinpoint Tests >> Pinpoint Test E: Engine Driven Cooling Fan Moan

Pinpoint Test E: Engine Driven Cooling Fan Moan

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. E1 CHECK THE ENGINE DRIVEN COOLING FAN AFTER A COLD SOAK 
    • Carry out the VEHICLE COLD SOAK PROCEDURE .
    • Key in START position.
    • Assess the airflow.
    • Raise the engine speed to 1500 rpm while listening for the moan to increase in proportion to the airflow.
    • Key in OFF position.
    • Does the moan increase in proportion to the airflow? 
    • Yes  : TEST the fan for normal operation. If the fan tests normal, GO to  E2. Otherwise, REPAIR as necessary.
    • No  : Normal system operation.
  2. E2 CHECK THE ENGINE DRIVEN COOLING FAN AT NORMAL OPERATING TEMPERATURE 
    • Key in START position.
    • Run the engine to normal operating temperature while listening for the moan to stop.
    • Key in OFF position.
    • Does the moan stop? 
    • Yes  : Normal clutch operation.
    • No  : INSTALL a new fan clutch. REFER to ENGINE COOLING . TEST the system for normal operation.
scientia non olet · About LEMON Manuals