LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 962 (Noise, Vibration & Harshness -- F150 Pickup) >> Diagnosis And Testing >> Noise, Vibration and Harshness (NVH) >> Component Tests >> Idle Air Control (IAC) Valve

Idle Air Control (IAC) Valve

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
    2. NOTE: Key symptom is elevated idle speed while noise is occurring.
    NOTE: "Snapping" the throttle can induce the noise.
  2. Verify the condition by operating the vehicle for a short time.
  3. Inspect the IAC valve. If physical evidence of contamination exists, install a new IAC valve.
  4. While the noise is occurring, either place an EngineEAR probe near the IAC valve and the inlet tube, or create a 6.35-mm (0.25-in) - 12.7-mm (0.50-in) air gap between the inlet tube and the clean air tube. If the IAC valve is making the noise, install a new IAC valve.
  5. Test the vehicle for normal operation.
scientia non olet · About LEMON Manuals