LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Engine Controls - Self-Diagnostics) >> System Tests >> Test ND: Engine Speed Signal >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.

This test is used to diagnose the following:

Clean Tachometer Output (CTO) circuit from PCM is monitored by TCM. DTC P0725 indicates TCM did not receive a proper voltage signal from PCM. Possible causes are as follows:

For DTC P0725, RPM PID should increase as accelerator pedal is slowly depressed while engine is running.

Fig 1: Identifying Clean Tachometer Output Circuits
G99J02334Courtesy of FORD MOTOR CO.