Retractor - Rear Safety Belt and Tongue, Crew Cab: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the safety belt webbing is not twisted prior to installation.

NOTE: Make sure to tighten bolts to specification.

NOTE: Inspect the shoulder safety belt guide and cover for damage. If the shoulder safety belt guide or cover is damaged or cover does not remain closed, install a new shoulder safety belt guide.

Fig 1: Identifying Rear Safety Belt And Tongue, Crew Cab Retractor Bolts Tightening Specification (1 Of 3)

Courtesy of FORD MOTOR CO.

Fig 2: Identifying Rear Safety Belt And Tongue, Crew Cab Retractor Bolts Tightening Specification (2 Of 3)

Courtesy of FORD MOTOR CO.

Fig 3: Identifying Rear Safety Belt And Tongue, Crew Cab Retractor Bolts Tightening Specification (3 Of 3)

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.
Check the restraint system for correct operation.