LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Wiper System & Washer System -- F250-F550 Super Duty) >> Removal And Installation >> Wiper Mounting Arm and Pivot Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cowl top vent panels. For additional information, refer to FRONT END BODY PANELS .
  2. Remove the wiper mounting arm and pivot shaft.
    1. Remove the five bolts.
    2. Disconnect electrical connector.
    3. Remove the wiper mounting arm and pivot shaft assembly.
      Fig 1: Removing Wiper Mounting Arm And Pivot Shaft
      G03926036Courtesy of FORD MOTOR CO.
  3. If necessary, remove the wiper motor. For additional information, refer to WIPER MOTOR  in this article.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals