LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 957 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Seat Track - With Seat Integrated Restraints (SIR) >> Installation

Seat Track - With Seat Integrated Restraints (SIR): Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    Manual seats 

  1. Place the seat tracks on the seat pedestal frame and install the seven screws (four outboard side, three inboard side).
    Fig 1: Installing Screws - With Torque Specifications
    G03925534Courtesy of FORD MOTOR CO.
  2. Attach the fore/aft adjuster bar and install new pushclips on each side. Attach the seat assist spring.
    Fig 2: Installing Pushclips
    G03925535Courtesy of FORD MOTOR CO.

    3. Power seats 

  3. Connect the seat actuator motor electrical connector.
    Fig 3: Connecting Seat Actuator Motor Electrical Connector
    G03925532Courtesy of FORD MOTOR CO.

    4. All seats 

  4. Install the front seat backrest. For additional information, refer to FRONT SEAT BACKREST - WITH SEAT INTEGRATED RESTRAINTS (SIR)  in this article.
  5. Install the front seat cushion. For additional information, refer to FRONT SEAT CUSHION - WITH SEAT INTEGRATED RESTRAINTS (SIR)  in this article.

    6. Power seats 

  6. Connect the seat control electrical connector.
    Fig 4: Connecting Seat Control Electrical Connector
    G03925530Courtesy of FORD MOTOR CO.

    7. Heated seats 

  7. Connect the heated seat switch electrical connector.
    Fig 5: Locating Heated Seat Switch Electrical Connector
    G03911415Courtesy of FORD MOTOR CO.

    8. All seats 

    CAUTION: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.
  8. Position the side trim cover and install the three trim cover screws.
    • The seat backrest pivot bolt shaft must be inserted into the cover standoff.
      Fig 6: Installing Trim Cover Screws
      G03925447Courtesy of FORD MOTOR CO.
  9. Push the rearward lower corner of the side shield to engage the metal retaining clip.
  10. Position the lumbar adjuster control and install the two mounting screws.
    • Install the adjuster knob.
      Fig 7: Installing Adjuster Knob
      G03925540Courtesy of FORD MOTOR CO.
  11. Position the seat back recliner lever cover and install the screw.
    Fig 8: Installing Screw
    G03925541Courtesy of FORD MOTOR CO.
  12. Install the front seat. For additional information, refer to FRONT SEAT - WITH SEAT INTEGRATED RESTRAINTS (SIR)  in this article.
scientia non olet · About LEMON Manuals