Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: New retaining bolts (W710721) must be installed, do not reuse the bolts that were removed. Retaining studs and nuts can be reused.

Remove the seat mounting retainer covers.
From the bottom of the seat backrest, push the seat backrest upward, then pull the bottom outward and remove from vehicle.

Fig 1: Removing Backrest
Courtesy of FORD MOTOR CO.
Position the seat cushions back, then remove and discard the retaining bolts.

Fig 2: Removing Retaining Bolts - With Torque Specifications
Courtesy of FORD MOTOR CO.
Remove and discard the retaining bolt.

Fig 3: Removing Retaining Bolt - With Torque Specifications
Courtesy of FORD MOTOR CO.
Remove and discard the retaining bolt and remove the retaining nut.

Fig 4: Removing Middle Seat Retaining Nuts - With Torque Specifications
Courtesy of FORD MOTOR CO.
Remove the retaining nut.

Fig 5: Removing Side Seat Retaining Nut - With Torque Specifications
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .
- Make sure the safety belt webbing is not twisted prior to installation.