LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 957 (Seat System -- F250-F550 Super Duty) >> Removal And Installation >> Rear Seat - Bench, Crew Cab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: New retaining bolts (W710721) must be installed, do not reuse the bolts that were removed. Retaining studs and nuts can be reused.
  1. Remove the seat mounting retainer covers.
    2. NOTE: Removing the rear seat requires more than one technician.
  2. Remove the rear seat.
    • Remove and discard the mounting retaining bolts.
    • Remove the mounting retaining nuts and remove the seat.
      Fig 1: Removing Rear Seat Mounting Retaining Nuts And Seat - With Torque Specifications
      G03925418Courtesy of FORD MOTOR CO.
    3. NOTE: When installing the seat, tighten the two new front mounting retaining bolts, then the rear two mounting retaining nuts.
  3. To install, reverse the removal procedure.
  4. Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .
    • Make sure the safety belt is not twisted prior to installation.
scientia non olet · About LEMON Manuals