Heated Seat Switch - With Seat Integrated Restraints (SIR): Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Install the heated seat switch into the trim panel and connect the heated seat switch electrical connector.
- Verify the switch locking tabs are securely seated.
  
  Fig 1: Locating Heated Seat Switch Electrical Connector
  Courtesy of FORD MOTOR CO.

CAUTION: Bend the side shield slightly to make sure the shield is not scratched by the recliner lever.

Position the side trim cover and install the three trim cover screws.
- The seat backrest pivot bolt shaft must be inserted into the cover standoff.
  
  Fig 2: Installing Trim Cover Screws
  Courtesy of FORD MOTOR CO.
Push the rearward lower corner of the side shield to engage the metal retaining clip.
Position the lumbar adjuster control and install the two mounting screws. Install the adjuster knob.

Fig 3: Installing Mounting Screws
Courtesy of FORD MOTOR CO.
Position the seat back recliner lever cover and install the screw.

Fig 4: Installing Screw
Courtesy of FORD MOTOR CO.
Install the front seat. For additional information, refer to FRONT SEAT - WITH SEAT INTEGRATED RESTRAINTS (SIR) in this article.