LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 955 (Exterior Trim And Ornamentation -- F250-F550 Super Duty) >> Removal And Installation >> Trim Panel - Body Side to Roof Moulding >> Installation

Trim Panel - Body Side to Roof Moulding: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean out all remaining sealant from the body side to roof joint and replace with Ford Caulking Cord D6AZ-19560-A or equivalent meeting Ford specification ESB-M4G32-A.
  2. Position a new body side-to-roof moulding (painted to match) on the vehicle and press into place.
  3. Install the nuts.
  4. Install the rear cab corner trim panel, safety belt and rear seat (if applicable).
scientia non olet · About LEMON Manuals