LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 950 (Antenna System -- F250-F550 Super Duty) >> Removal And Installation >> Antenna Base >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the radio antenna mast.
  2. Remove the RH cowl vent grille. For additional information, refer to FRONT END BODY PANELS .
  3. Remove the 3 screws and the antenna base.
    Fig 1: Removing Screws And Antenna Base
    G03924946Courtesy of FORD MOTOR CO.
  4. Disconnect the radio antenna lead-in cable.
    Fig 2: Disconnecting Radio Antenna Lead-In Cable
    G03910923Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals