LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 948 (Parking Aid System -- F250-F550 Super Duty) >> Removal And Installation >> Parking Aid Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Parking aid switch shown removed for clarity.
    Fig 1: Removing Parking Aid Switch Trim Plate By Gently Prying Plate Out Of Instrument Panel
    G03924824Courtesy of FORD MOTOR CO.
  1. Remove the parking aid switch trim plate by gently prying the plate out of the instrument panel.
  2. Remove the parking aid switch.
    1. Disconnect the electrical connectors from the parking aid switch, rear defrost switch (if equipped), and transfer case control switch (if equipped).
    2. Release the locking tabs that retain the parking aid switch to the switch plate.
    3. Remove the parking aid switch from the switch plate.
      Fig 2: Removing Parking Aid Switch
      G03924825Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals