Pinpoint Test A: No Communication With The Parking Aid Module

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

A1 CHECK PARKING AID MODULE CIRCUIT 295 (LB/PK) FOR VOLTAGE
- Key in OFF position.
- Disconnect: Parking Aid Module C4014.
- Key in ON position.
- Measure the voltage between the parking aid module C4014 pin 1, circuit 295 (LB/PK), harness side and ground.
  
  Fig 1: Checking Parking Aid Module Circuit 295 (LB/PK) For Voltage
  Courtesy of FORD MOTOR CO.
- Is the voltage greater than 10 volts?
1. Yes : GO to A2.
2. No : REPAIR the circuit. TEST the system for normal operation.
A2 CHECK CIRCUIT 57 (BK) FOR AN OPEN
- Key in OFF position.
- Measure the resistance between the parking aid module C4014 pin 3, circuit 57 (BK), harness side and ground.
  
  Fig 2: Checking Circuit 57 (BK) For Open
  Courtesy of FORD MOTOR CO.
- Is the resistance less than 5 ohms?
1. Yes : REFER to MODULE COMMUNICATIONS NETWORK to continue diagnosis of the communication network.
2. No : REPAIR the circuit. TEST the system for normal operation.