Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Move the front seat forward.
Move the front seatback forward.
If equipped, remove the utility tray behind the seat. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Pull the carpet, or mat back to see the rear body insulator bolt head .
Remove and discard the bolt.

Fig 1: Identifying Removing Bolt
Courtesy of FORD MOTOR CO.
Remove the insulator.

Fig 2: Locating Lower Body Mount Insulator
Courtesy of FORD MOTOR CO.

NOTE: Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.

NOTE: No lubricants of any kind are to be used during body insulator installation.

Fig 3: Bolt With Torque Specification

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.