LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 940 (Full Frame And Body Mounting -- F250-F550 Super Duty) >> Removal And Installation >> Body Support - Middle, Crew Cab, Lower >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move the front seat forward.
  2. Remove the rear door cowl side trim panel (02345). For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Pull the carpet or mat back to expose the middle body insulator button plug.
    Fig 1: Locating Middle Body Insulator Button Plug
    G03926318Courtesy of FORD MOTOR CO.
  4. Remove the plug.
  5. Remove and discard the bolt.
    Fig 2: Identifying Removing Bolt
    G03926319Courtesy of FORD MOTOR CO.
  6. Remove the insulator.
    Fig 3: Locating Lower Body Mount Insulator
    G03912147Courtesy of FORD MOTOR CO.
    7. NOTE: Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
    NOTE: No lubricants of any kind are to be used during body insulator installation.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals