LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Engine Controls - System & Component Tests - EEC-V - NGV) >> Computerized Engine Controls >> Natural Gas Vehicle Module >> Power Circuits

Power Circuits

WARNING: This page is about a different car, the 2002 Ford Pickup, 2002 Ford Econoline, 2002 Ford Cutaway, and 2002 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition off. Ensure NGVM 60-pin connector is disconnected. Turn ignition on. Using DVOM, check for battery voltage between chassis ground and NGVM connector terminals No. 1, 37 and 57 (VPWR). If battery voltage is not present, repair open in affected circuit as necessary. See WIRING DIAGRAMS article.

scientia non olet · About LEMON Manuals