LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 937 (Glow Plug System -- F250-F550 Super Duty 6.0L) >> Removal And Installation >> Glow Plug Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cables. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the push pin retainer, injection control pressure (ICP) electrical connector and glow plug connectors.
    Fig 1: Locating Injection Control Pressure (ICP) Electrical Connector And Glow Plug Connectors
    G03906822Courtesy of FORD MOTOR CO.
  3. Remove the two nuts and the glow plug relay.
    Fig 2: Removing/Installing Nuts And Glow Plug Relay
    G03907978Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals