Electronic Automatic Temperature Control Module - Diagnostic Methods
WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
The electronic automatic temperature control system must be diagnosed by first retrieving any DTCs, if present.
- An on-demand (hard fault) DTC indicates that the fault is currently present. An on-demand DTC suggests a wiring fault, disconnected connector, or component failure.
- A continuous (intermittent) DTC alone (corresponding on-demand DTC is not present) indicates that the fault is an intermittent condition and may not be currently present. A continuous only DTC suggests a poor wiring connection, loose pin or terminal, or intermittent component failure.
On-demand (hard fault) or continuous (intermittent fault) DTCs can be retrieved using a diagnostic tool. If using a diagnostic tool, refer to the diagnostic tool operating manual.
On-demand DTCs can also be retrieved by carrying out the Electronic Automatic Temperature Control Module Self-Test. To retrieve and/or clear continuous DTCs carry out the Electronic Automatic Temperature Control Module - Retrieve Continuous DTCs procedure. Always carry out the Electronic Automatic Temperature Control Module Self-Test before retrieving continuous DTCs.
If no DTCs are present, GO to SYMPTOM CHART for the appropriate diagnostic action.