LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 932 (Fuel System - General Information -- F250-F550 Super Duty) >> General Procedures >> Spring Lock Couplings >> Disconnect

Spring Lock Couplings: Disconnect

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke, carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and can be ignited. Failure to follow these instructions may result in personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before servicing or disconnecting any of the fuel lines or fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing personal injury or a fire hazard.
  1. Relieve the fuel pressure. For additional information, refer to FUEL SYSTEM PRESSURE RELEASE - GASOLINE ENGINES  or FUEL SYSTEM PRESSURE RELEASE - DIESEL ENGINES ..
  2. Remove the fuel tube clip.
    Fig 1: View Of Fuel Tube And Clip
    G03883081Courtesy of FORD MOTOR CO.
  3. Install the special tool.
    Fig 2: Installing Special Tool
    G03924101Courtesy of FORD MOTOR CO.
  4. Close and push the special tool into the open side of the cage.
    Fig 3: Closing And Pushing Special Tool Into Open Side Of Cage
    G03924102Courtesy of FORD MOTOR CO.
  5. Separate the fitting.
    Fig 4: Separating Fitting
    G03924103Courtesy of FORD MOTOR CO.
  6. Remove the special tool.
    Fig 5: Removing Disconnect Tool
    G03924104Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals