Spring Lock Couplings: Connect

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Inspect and clean both coupling ends. Install new O-ring seals and garter springs if necessary.
- Lubricate the O-ring seals with clean engine oil.
  
  Fig 1: Lubricating O-Ring Seals With Clean Engine Oil
  Courtesy of FORD MOTOR CO.
Fit the male fitting into the female end and push until the garter spring snaps over the flared end of the female fitting.

Fig 2: Connecting Coupling Ends
Courtesy of FORD MOTOR CO.
Make sure the coupling is engaged by pulling on the lines and install the safety clip.

Fig 3: Checking Coupling Connection
Courtesy of FORD MOTOR CO.