LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Engine Controls - System & Component Tests - EEC-V - Bi-Fuel) >> Computerized Engine Controls >> Powertrain Control Module >> Ground Circuits

Ground Circuits

WARNING: This page is about a different car, the 2002 Ford Pickup and 2002 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition off. Disconnect PCM 104-pin connector. PCM is located on right rear of engine compartment. Using DVOM, check for continuity between chassis ground and PCM harness connector terminals No. 3, 25, 51, 76 and 103. See Figure. If continuity exists, see POWER CIRCUITS . If continuity does not exist, repair open in affected ground circuit. See WIRING DIAGRAMS article.

scientia non olet · About LEMON Manuals