LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 929 (Handles, Locks, Latches And Entry Systems -- F250-F550 Super Duty) >> Removal And Installation >> Door Lock Cylinder >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Remove the exterior front door handle. For additional information, refer to EXTERIOR FRONT DOOR HANDLE  in this article.
  3. Remove the front door lock cylinder.
    1. Remove the clip.
    2. Remove the lock cylinder.
      Fig 1: Removing Front Door Lock Cylinder
      G03911843Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals