LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 924 (Electronic Engine Control System -- Diesel Engine -- F250-F550 Super Duty) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Always disconnect the battery ground cable prior to working on the electronic engine controls.
  1. Disconnect the battery ground cable. For additional information, on vehicles equipped with dual batteries, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the auxiliary battery positive cable (LH side of the engine compartment).
    Fig 1: Disconnecting Auxiliary Battery Positive Cable (LH Side Of Engine Compartment)
    G03908106Courtesy of FORD MOTOR CO.
  3. Remove the auxiliary battery cover.
    Fig 2: Removing Auxiliary Battery Cover
    G03908107Courtesy of FORD MOTOR CO.
  4. Unlatch and disconnect the powertrain control module (PCM) electrical connectors.
    Fig 3: Disconnecting Powertrain Control Module Electrical Connectors
    G03908108Courtesy of FORD MOTOR CO.
  5. Remove the bolts and PCM.
    Fig 4: Removing/Installing PCM Bolts With Torque Specifications
    G03908109Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals