LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 919 (Exterior Lighting System -- F250-F550 Super Duty) >> Removal And Installation >> Lamp Switch - Headlamp >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Position the steering wheel in the lowest position.
  3. Carefully pull out the instrument cluster finish panel enough to gain access to the back of the headlamp switch.
    Fig 1: Pulling Out Instrument Cluster Finish Panel Enough To Gain Access To Back Of Headlamp Switch
    G03925078Courtesy of FORD MOTOR CO.
  4. Reach behind the instrument cluster finish panel and release the headlamp switch from the instrument cluster finish panel.
    • Feel for flat surfaces on the headlamp switch and push the switch outward until the headlamp switch pops out.
  5. Disconnect the electrical connectors and remove the headlamp switch.
    Fig 2: Disconnecting Electrical Connectors And Removing Headlamp Switch
    G03925079Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals