LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 916 (Interior Trim And Ornamentation -- F250-F550 Super Duty) >> Removal And Installation >> Headliner - Regular Cab, SuperCab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. If equipped, remove the overhead console.
    • Release the locking tabs while pulling down.
  2. Remove the left and right screws and visors.
    • If equipped, disconnect the electrical connector.
      Fig 1: Disconnecting Electrical Connector
      G03925288Courtesy of FORD MOTOR CO.
  3. Position the left and right front door opening weatherstrips down from the headliner.
    Fig 2: Positioning Left And Right Front Door Opening Weatherstrips
    G03911266Courtesy of FORD MOTOR CO.
  4. Remove the left and right windshield side garnish moulding. For additional information, refer to MOULDING - WINDSHIELD SIDE GARNISH  in this article.
  5. NOTE: SuperCab shown, regular cab similar.
    Fig 3: Removing Courtesy Lamp Lens
    G03911279Courtesy of FORD MOTOR CO.
  6. Remove the courtesy lamp lens, then remove the screws.
  7. SuperCab vehicles 

  8. Remove the left and right rear door striker covers at the roof trim panel.
    Fig 4: Removing Left And Right Rear Door Striker Covers
    G03925291Courtesy of FORD MOTOR CO.
  9. If equipped, remove the safety belt shoulder height adjuster cover pin-type retainers.
    Fig 5: Removing Safety Belt Shoulder Height Adjuster Cover Pin-Type Retainers
    G03925292Courtesy of FORD MOTOR CO.
  10. If equipped, remove the safety belt shoulder height adjusters.
    1. Position the safety belt shoulder height adjuster cover down.
    2. Remove the bolt.
    3. Remove the safety belt shoulder height adjuster.
      Fig 6: Removing Safety Belt Shoulder Height Adjuster
      G03925293Courtesy of FORD MOTOR CO.
  11. Remove the two headliner rear pin-type retainers.
    Fig 7: Removing Two Headliner Rear Pin-Type Retainers
    G03925294Courtesy of FORD MOTOR CO.
  12. All vehicles 

  13. Remove both of the left and right safety belt guides.
    1. Position the shoulder safety belt guide cover up.
    2. Remove the shoulder safety belt guide nut.
    3. Remove the shoulder safety belt guide.
      Fig 8: Removing Both Of Left And Right Safety Belt Guides
      G03925265Courtesy of FORD MOTOR CO.
  14. Remove the left and right coat hooks.
    Fig 9: Removing Left And Right Coat Hooks
    G03925296Courtesy of FORD MOTOR CO.
  15. Remove the assist handle.
    1. Remove the covers and bolts.
    2. Remove the assist handle.
      Fig 10: Removing Assist Handle
      G03916546Courtesy of FORD MOTOR CO.
  16. Position aside the rear corner trim panels.
    Fig 11: Positioning Aside Rear Corner Trim Panels
    G03925298Courtesy of FORD MOTOR CO.
  17. Remove the two headliner front pin-type retainers.
    Fig 12: Removing Headliner Front Pin-Type Retainers
    G03911282Courtesy of FORD MOTOR CO.
  18. Remove the headliner.
  19. To install, reverse the removal procedure.